Paramount Paralevel Start Up Kit (2011 and Newer)

Paramount Paralevel 2011 Start Up Kit.

The Paralevel is designed to control the water level in a swimming pool or spa. The "Posi-Click" control makes adjusting the water level very easy. Four clicks (or one revolution) of the adjustment wheel changes the water level by 1/4 inch.

The Paralevel uses "Smart Sensing", eliminating rapid cycling of the device even when the pool is being used.

The user can use 1-1/2 inch or 2 inch pipe for the balance line. The water line can be plumbed with 1/2 inch or 3/4 inch pipe. The Paralevel can also be plumbed with 2 inch pipe for overflow protection, offering the highest overflow protection in the industry.

Using a new float in an older tank:

• While holding the new float, twist sleeve counter clockwise until it comes out of the float. 
• Turn float over and re-thread on sleeve with flat side up. Be careful not to cross-thread. (Fig. 12) 
• Compare the float height on the sleeve to the old float. The new style float will need to be approximately 5/8 inch lower on the sleeve to achieve a similar water level. (Fig. 13) 
• Install in the housing and turn on the water supply. 
• If the float is off, shut off the water and remove the float and turn in the direction indicated on the flat side of the float to raise the water level 1/8 inch, one half turn, or 2 posi-clicks. Follow the arrows on the float. (Fig. 14) 
• If the float is on, shut off the water and remove the float and turn in the direction indicated on the flat side of the float to raise the water level 1/8 inch, one half turn, or two (2) posi-clicks. Follow the arrows on the float. (Fig. 14) 
• Repeat steps 5a or 5b until water level is matched. 
• Check pool level after a few days to verify correct set level.

Part# 004-760-2921-00