Aquastar 8in. Retrofit Hockey Puck Sumpless Suction Outlet Cover - Taupe #R8HP107

This item has been discontinued by the manufacturer. The manufacturer made a new model called MoFlow. Check out the colors available to find one closest to fit your needs.

Features
For single or multiple drain use in existing frames and sumps
Single
Floor/wall: 224 GPM at 6.3 fps
Floor/wall: 74.3 GPM at 1.5 fps
No sump required
15.8 square inch opening
Three sets of different stainless steel screws
Manufactured from superior UV-resistant engineered polymers
Easily and safely retrofits most brands‚’ existing 8" frames and sumps that the 8HPxxx does not fit
Patent-pending Flow-Star‚® technology
Meets or exceeds NSF 50/ASME/ANSI A112.19.8a-2008 national standards and ASTM G154 UV testing
Listed with IAPMO R&T
Trademarked VGB compliance button easily identifies VGB 2008 compliant cover from on deck and underwater

Special Notes

• 6HP, 8HP & R8HP MAX Flow is 224 gpm allowed for both floor and wall with 2"or greater pipe sizes
• When 1.5" pipe size is used, max flow rate allowed for the 6hp, 8hp & r8hp is 177 gpm and 122 gpm for floor and wall respectively
• 4HP max flow is 56 gpm allowed only for wall applications
• 4SPA is for use in self-contained, factory-manufactured portable spas and hot tubs only and for multiple drain use only. Flow rate above is for two suction outlets.
• No sump is required. Aquastar's "Sumpless series" are designed and tested for safe flush-mount installations to tile, fiberglass, Acrylic, vinyl and steel as well as plaster, pebble, concrete, etc.
• ABS bulkhead adapter fitting must be securely attached to plumbing with proper glue. Use abs to PVC transitional glues (such as: Oatey ‚® ‚ Weld-on ‚® and other green NSF glues)
• DO NOT use clear, "hot", "blue" or any fast set glues with any AquaStar pool products
• Especially when retro-fitting, extra secure installations can be obtained by applying wet and dry epoxy, silicone, etc. to underside of base plates.
• After installation of bulkhead adapter fittings, if a gap exists between pool finish and base of cover it must be filled in with a 2-part epoxy to avoid finger or other entrapment.